Quick summary
Locate the water first: front (filter or door), back (hoses and connections), drawer (suds or a blocked drawer), or underneath with no visible source (an internal leak that needs a technician). Cut power and close the tap for any obvious leak.
A leaking washer can damage floors and create an electrical hazard. The key step is finding the exact source, because the fix for a loose hose differs completely from a tub leak.
Unplug the appliance, close the water tap if there's a leak, and never open covers that need tools or expose wiring or circuits.
Possible causes
Inlet hose connections
A loose connection or worn washer at the tap or behind the machine drips even when the washer is off.
Pump filter cap not sealed
If not refitted properly after cleaning, water leaks at the front bottom.
Detergent drawer and excess suds
Too much detergent or a blocked drawer channel makes water and foam overflow.
Drain hose
A cracked hose or its end slipping out of the drain while pumping.
Internal leak
Internal hoses, pump or tub seal—water appears underneath with no external source.
Safe checks you can do
- Unplug, close the washer tap and dry the floor.
- Dry the hoses and joints with tissue, open the tap only (don't run) and watch for drips.
- Check the pump filter cap is screwed in fully.
- Remove and clean the detergent drawer and use the recommended detergent dose.
- Make sure the drain hose end is secured in the drain.
- If no external source appears, run a short program while watching, with paper towels around the base.
When to stop checking immediately
- If water reaches the socket or cables—don't touch the plug with wet hands; switch off the breaker first.
- If water comes from underneath with no visible external cause.
Related components
- Inlet & drain hoses
- Drain pump
- Pump filter
- Door & lock
When do you need a technician?
Internal leaks require opening the appliance safely: the technician inspects internal hoses, pump, tub seal and sump, then runs a full test cycle after repair to confirm the leak is gone.
Related error codes
FAQ
It only leaks during spin—why?
Likely the drain hose, pump or an internal joint stressed by vibration. Note where the water appears.
Should I unplug the washer if it leaks?
Yes. Cut power safely and close the water tap before checking.
Related guides
Water Leaking From the LG Washer Door: Gasket, Overloading and Suds
Water leaking from your LG front-loader door? Dirty or torn door gaskets, overloading and suds explained, with safe cleaning and checks.
LG Washer Keeps Filling: The FE Code and the Water-Level Sensor
LG washer won't stop filling, overfills or shows FE? Inlet valve and pressure sensor causes—and how it differs from siphoning.
LG Washer Not Draining: Causes, the OE Code and Safe Checks
LG washing machine not draining or showing OE? Learn how a blocked pump filter, kinked hose or failing drain pump causes it, plus safe checks before calling a technician.
Low Water Pressure From Rooftop Tanks and Its Effect on LG Washers and Dishwashers
Why LG washers and dishwashers fill slowly in many Jordanian homes: how rooftop tanks affect pressure and the IE code, plus practical fixes.